A 35 Nm tubular motor running on 24V DC covers a narrow slice of shading work, and that slice keeps coming up. Installers reach for the Somfy Simu T5 35Nm 7rpm 24V DC (2004497) when the roller sits where no 120V feed reaches, or when a low-voltage panel already drives the rest of the shades on the job. Somfy rates the motor for awnings, exterior solar screens, interior shades and rolling shutters. It holds the top torque step in the T5 DC range.

A 35 Nm motor on a low-voltage supply
Torque sets the shade weight the motor will lift, and 7 rpm sets how long the run takes. At 35 Nm the 2004497 handles heavy awning fabric and large exterior screens on a 50 mm tube class. The slow speed suits tall drops where a fast motor would slam the hem bar into its stop.
Somfy publishes the ref as T5 35/07 24V DC C2.5M WH CEM/1. The motor draws 2.3 A and 55 W while it runs, and 0 W once it stops. Input voltage spans 18V to 30V DC, which gives the circuit room for cable loss on a long home run. Class III insulation and an IP 44 rating cover the exterior cases Somfy lists.
Tube class, crown and drive for the round pin head
The motor body measures 45 mm across, and the head carries the round pin pattern Somfy uses through the T5 line. Fitment runs through the parts you order alongside it. A crown centers the motor inside the tube. A drive wheel transfers torque to the tube wall. A bracket carries the head at the drive end, and an idler closes the far end. Match every one of them to the tube you already have.
For a 2.5 inch round tube, pair the Somfy LT50 2.5" Crown (9707026) with the Somfy LT50 2.5" Soft Clip Drive (9206041). Octagonal tube takes a different set. The Somfy 60mm Octagonal LT50/60 Aluminum Drive With Stop (9012951) seats in 60 mm octagonal profile and brings its own stop collar. Somfy also lists 50 mm and 70 mm octagonal sets plus 78 mm and 85 mm round sets against this ref, so most awning tube on the market has a published match.

Verified Somfy specs
| Specification | Published figure |
|---|---|
| Somfy reference | 2004497 |
| Torque | 35 Nm |
| Speed | 7 rpm |
| Power supply | 24V DC, 18V to 30V range |
| Rated current | 2.3 A |
| Consumption running | 55 W |
| Consumption standby | 0 W |
| External diameter | 45 mm (1.77 in) |
| Length | 621 mm (24.45 in) |
| Limit switch | Mechanical, 28 turns |
| Head type | Round with pins |
| Cable | VVF, 2.5 m (8.2 ft), 4 conductor, 0.75 mm², stripped ends, white |
| Protection | IP 44, Class III insulation |
| Operating temperature | -20 °C to 60 °C (-4 °F to 140 °F) |
| Thermal cut-out | 4 min |
| Warranty | 5 years |
Figures come from Somfy's published e-catalogue entry for ref 2004497.
Four wires and one low-voltage circuit
The cable leaves the head as a 2.5 m VVF lead with four stripped conductors at 0.75 mm². Two carry direction, and the pair that remains carries the DC supply. Reverse the two polarity conductors and the shade travels the other way, which is the fix when a shade rolls off the back of the tube on first test.
Size the supply from the current draw. One motor pulls 2.3 A, so a pair sharing a transformer asks for 5 A of headroom before inrush. Keep the run short where the budget allows. The 18V floor gives you margin, and a thin conductor over a long distance eats into it fast. Somfy publishes no radio receiver inside this motor, so control arrives through a switch, a dry contact output, or a DC receiver wired ahead of the motor.
Mechanical limits and the 28-turn ceiling
Two mechanical limit switches set the upper and lower stops, and you turn them with the adjustment keys on the head. The switch unit holds 28 turns of travel. Tube circumference decides what that converts to in inches of drop, so a 2.5 inch tube at roughly 7.85 inches per turn reaches around 18 feet of travel before fabric build-up changes the math. Most awning and screen drops land well inside it.
Set the limits before the fabric goes on wherever the design allows. Thermal protection cuts the motor after 4 minutes of continuous run, and at 7 rpm a long test cycle gets close to that. Give the motor a rest between runs during commissioning.
Brackets and mounting for the T5 head
Somfy lists several bracket patterns against this ref, and the square plate covers most awning hoods. The Somfy Simu T5 Operator Bracket 80mm x 80mm Square (9520049) bolts to a flat surface and takes the round pin head without an adapter. A 100 mm square plate, a 48 mm plate and a 10 mm pin mount cover the frames the square plate misses.
Check the head clearance before you cut the tube. The motor measures 621 mm overall, and Somfy publishes a riveting position 598 mm from the drive end, which tells you where the tube rivet lands. Subtract the bracket and the idler end from your opening, then cut.
The Simu T5 35Nm 7rpm 24V DC (2004497) arrives as a motor with its lead. Nothing for the tube comes in the box. Decide the tube profile first, then add the crown and drive set that matches it, then the bracket your frame takes. Builders running the rest of a job on 120V will want the T5 standard range instead, since this ref expects a DC supply.
FAQ
What tube does the Simu T5 2004497 fit?
The motor body measures 45 mm across and belongs to the Simu T5 50 mm class. Somfy publishes crown and drive sets for 50 mm, 60 mm and 70 mm octagonal tube plus 2 inch, 2.5 inch, 78 mm and 85 mm round tube against this reference. Pick the set that matches your profile and inside dimension.
Does this motor work with a Somfy RTS remote?
Somfy builds no radio receiver into the 2004497. Control comes from a wired switch or a dry contact output. Adding a separate 24V DC radio receiver ahead of the motor brings remote control to the circuit, and the receiver handles the radio side.
What power supply does it need?
Feed it 24V DC. Somfy publishes an input range of 18V to 30V, a rated current of 2.3 A and 55 W consumption while the motor runs. Standby draw sits at 0 W. Size the transformer for every motor on the circuit with headroom above the combined current.
How much travel do 28 turns give?
The mechanical limit unit holds 28 turns. Multiply the tube circumference by 28 for the ceiling. A 2.5 inch tube yields roughly 18 feet before fabric thickness on the roll reduces it. Awning and exterior screen drops stay well inside that figure.
Shade Motors Direct is an authorized source for genuine Somfy motorized window shade, blind, and drapery parts.


